Posted by skyhiranger on October 27, 2012 at 17:51:04 from (71.49.75.59):
In Reply to: Valve guide seals posted by ZANE on October 27, 2012 at 16:48:33:
Quoting Removed, click Modern View to see
Ok, I can try to do that, but I am not sure if I can get the guide pushed down in there. I put some pretty good pressure on it before (by prying down on the top of the guide by going through the intake port), and the seal just kinda squished.
The thing that confused me, is that I read before where someone said the only place that the seal can catch is where the intake port hole is in the side of the valve pocket. This particular engine is definitely different that what they were stating.
Yep, I'm just putting new seals on the intake guides.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.