Posted by William S on October 03, 2012 at 12:42:51 from (69.129.92.62):
Sorry abt the delay in getting back to you all. had to split the 9n and R&R the clutch and the main shaft seal. It took abit of doing but all is back together. Being that I didn"t have a decent floor jack for the front-end, I made a sled to slide the engine down after splitting. A couple of wedges kept it level and re-connecting took 15 minutes. Now, as for the hydraulic problems,,,,the valves need rplcing and I have received all the neeeded gaskets and parts to complete the job. It does appear that the linkage is bent somewhere along the way as well. I have drained the fluid and need to inspect the linkage for proper angles or alignment. AS I have read on previous posts, now is the time to clean the sludge out of the pump section. Is kerosene the preferred cleaner? I looked at other cleaning options at the auto parts store and opted for kerosene, just wanted to make sure I was getting the right cleaner. It"s not easy to locate kerosene at the local service station anymore! Heck it is hard to locate a "service station". Thanks for your help. William
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
