Posted by elmersooner on February 20, 2012 at 19:16:38 from (69.8.51.222):
In Reply to: OT-Spotlight posted by G6 at Snook, TX on February 19, 2012 at 18:48:47:
I have a fellow that comes out of the city that has a high fence hunting setup and he pays a little cash for them. we have shot them in the trap and caught more the same day. we built our own traps. the swing door is angled slightly with a little hook holding it up, the hook on a trip wire made of a cable-they root around hit the wire it pulls the hook and the door swings shut- the door is made to where they can't push their way out, but ones on the outside can push their way in. we leave the top open so deer can jump out. I have a trailer that lowers so I can load them up. traps are by far the best way to keep the numbers in check. the rest of the trap is hog panel attached to T-posts. just make it stout and they won't get out. the state trapper stopped by earlier this year and he has a portable trap that is set up like mine, but is portable in panels that stake to the ground with auger style anchors.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.