Ford 9N, 2N & 8N Discussion Board |
Re: ford 8n governor linkage
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by condorf on May 24, 2005 at 16:45:10 from (65.37.80.189):
In Reply to: Re: ford 8n governor linkage posted by Rob on May 18, 2005 at 09:09:45:
Rob, thanks for all of your help. My 8n is on the road to recovery. When I couldn't start it over the winter it was a surprise as it had always run perfectly. I ended up installing a new manifold as I found that the old one was cracked. The carb was sloppy at the linkage and I went for a new one. The spark was weak and I installed new points and condensor...still little improvement in the spark so a new coil was next.Good spark now. Still it would not start unless we sprayed gas into the new carb , then it ran good. My neighbor has a 9n and he removed his carb and installed it on my 8n and it started right up...guess it was a faulty new carb. I'm going to install a rebuilt carb and assume all will be ok. Thanks again for your help.
Follow Ups:
Home
| Forums
Today's Featured Article -
Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|