Ford 9N, 2N & 8N Discussion Board |
Re: How should Bush Hog blades be sharpened?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rob on June 30, 2003 at 03:52:40 from (63.245.133.87):
In Reply to: How should Bush Hog blades be sharpened? posted by Popster (MD) on June 29, 2003 at 20:43:11:
I stood my hog straight up on the 3pt hitch gear and tied the tail wheel to a chain hanging from a low 12" tree branch. Stand up job. That thing stands pretty good on that gear, stable and no chance it will drop with that chain like that. I got it there using the boom pole on my 3pt. Maintain the same bevel on the blades and try hard to remove the same amount of mat'l from each blade to keep the weight and balance even. Even if one blade doesn't need that much sharpening, you want balance. When you get them sharp then file the sharp leading edge of the blade. You want a 1/16"+ flat leading edge so that too sharp edge doesn't roll back and undo your sharpening effort. Deburr them with a stone or hardwood and you are fini. Can't hurt to wire brush the bolts and set screws under there and squirt Knock-er-loose on that stuff and oil or grease or something to seal them because who knows one day you might want to take them apart. Better then nothing at all. Won't take much. Might be a waste of time, won't hurt.
Follow Ups:
Home
| Forums
Today's Featured Article -
Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|