Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Ford 9N, 2N & 8N Discussion Board

Re: Re: Re: Re: No more choke required while runni


[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by '52 8N (MD) on June 28, 2003 at 04:43:03 from (209.163.100.89):

In Reply to: Re: Re: Re: No more choke required while running posted by Rodney on June 27, 2003 at 13:30:25:

Rodney - The WD40 or carb cleaner are both a volatile organic compound or VOC. This just means they both burn. If you have a leak on the intake and you spray it into the leak your engine will start to run faster since it is getting extra fuel. The other two filters are in the gas tank and sediment bowl/petcock assy.
I know it's a pain, but you might just want to break down and remove the hood and gas tank and refurbish and coat the thing on the inside with Breem or some other product.
Let me finish with a short story. After rebuilding my carb with a New Holland kit everything ran fine. I discovered an old extra carb on the shelf in the barn so, since I still had some extra parts left over, I decided to rebuild it as well. The 90 degree fuel inlet strainer in the old carb looked so much better than the one I had in the tractor, I decided to swap it. When I went to hook up the new one to the fuel line I had a little trouble so I had to bend the fuel line a little to get it to thread properly. As a result of bending the line, some junk got loose on the inside and got in between my float needle and seat in my carb. When I went to start the tractor it not only would not start but gas came immediately spilling forth out of it's belly. The moral is just that little bit of bending the fuel and swapping out the strainer got me into a jam. This is why I suspect that you need to go back into the carb. wc


Follow Ups:




Post A Followup

:
:

: Re: Re: Re: Re: Re: No more choke required while runni

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series). ... [Read Article]

Latest Ad: Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy