Ford 9N, 2N & 8N Discussion Board |
Re: Light fuse (again)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Salmoneye on June 09, 2003 at 03:58:44 from (65.19.73.252):
In Reply to: Light fuse (again) posted by '52 8N (MD) on June 08, 2003 at 17:04:02:
Um...Unless I remember incorrectly...Doesn't the 'formula' go: Watts=Volts x Amps ??? 30+30=60 watts total, so 60watts=6Volts x 10Amps Minimum fuse you can use for JUST the headlights is 10 AMP if you are still 6-Volt...If you plan on adding tail and work lights you will need even bigger fuses or seperate fused lines... And as for (18AWG so it would fit into the headlight shell), Huh?...The hole in the tube that connects the headlight to the dogleg is hollow (at least on my lights) and will easily take 10 guage wire, though that is a tad overkill and a bugger to thread sometimes...
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|