Ford 9N, 2N and 8N Discussion Board |
Re: Ford 8n with live power and hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Ford 9N, 2N and 8N Discussion Board ]
Posted by Jim on March 21, 2000 at 16:47:15 from (216.80.148.241):
In Reply to: Ford 8n with live power and hydraulics posted by ROD on March 21, 2000 at 04:44:11:
The PTO shaft drives the pump for both 2,9 and 8Ns. If the hydraulics go up with the clutch in and the shaft not turning then you have something liken to perpetual motion! It is possible but not likely tht someone made a clutch pack like the NAAs had but I for one would have to see it. Pull the hand hole cover off and look in there if you can still get power out of the PTO shaft with the tractor in gear and clutch down.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|