Posted by t.r.k. on January 21, 2014 at 17:57:14 from (22.214.171.124):
In Reply to: zae front end posted by nl00sb on January 20, 2014 at 17:27:09:
1. Support the tractor. There is a nice flat spot under the rear of the oil pan. 1. Disconnect the steering shaft and any electric wiring, if present. 2. Drain and remove the radiator. I think there are 2 bolts behind, one in front, one up from the bottom on each side. 3. Support the front end. Six bolts hold it to the engine. You will probably have to raise the engine about 2-3 inches for the front crank pulley to clear so you can move the front bolster away. 4. Reverse the procedure to reassemble.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.