Posted by pmer on August 01, 2013 at 11:53:11 from (75.234.29.98):
I have a G vi with a 800 6A intended for tractor pulling and I'm having trouble getting the governor to behave.
I tried to connect the throttle a couple ways:
On the left side, below governor, pushing the spring towards the radiator but it takes to much force and the RPMs don"t seem to change as quick as it should. (tried pushing to increase RPMs)
Next I tried the right side, I connected a pull type spring to the throttle shaft that connects between carb and governor. Like a Oliver 77/88 gas set up. With the gov. spring connected on the left side I thought this would work but it eventually goes to full throttle and doesn"t respond to moving the throttle lever back to idle position.
Hopefully I can get some tips or see a picture of how the throttle should be connected.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.