I have never tried to post pictures on this site. But we will try. The parts book page is on another computer and it is shut down now, will post it in the morning. Hope you can tell by these pictures what I am talking about.The one picture shows where the vent tube goes in the right rear of the Hyd box. The one shows were the vent pipe comes from the left side of the engine behind the engine block and in front of the LP tank. The other shows the fill pipe. This pipe is shorter than the one on yours. I think the parts book gives the length. Now looking at it one would say the fill level is higher than the vent so fluid is going to run into the engine. But the parts book says there is a stand pipe on the inside of that vent pipe connection. Since you don't know the history of yours you will have to make sure that it is in place. There is two ways you can check. One of course would be to take the side plate off and look in. The other would be to take your plug out and fill with fluid and see if it runs out the vent fitting before it gets full. If not you should be OK. You might want to shorten your fill pipe so you can't overfill.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Magic Moments - by Tyler J. Woods. Magic moments don’t just happen. You have to help them along. This morning, I got up early. It is my day off from my regular workweek and I had a lot of things to do. It’s fall, and with winter coming on, there is a lot of work to do before weather closes in.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
