Posted by JWL on December 19, 2012 at 06:18:42 from (69.157.9.37):
Recently I was setting the valve lash on our MM U302 gas and I noticed that the timing marks on the flywheel only coincided with pistons #2 and 3 were at TDC. I know depending on the bolt spacing on the flywheel that some can be installed 180 degrees off or in certain cases they can either be installed at any orientation or only one specific way but I am unsure as to how the flywheel is on a U302 but it seems unconventional to have the timing marks line up when pistons #2 and 3 are TDC. This motor was rebuilt years ago and I would just like confirmation regarding how the flywheel is supposed to be installed from factory.
Also, my tech manual does not describe or illustrate how the valve tappets are to be set like it does for the M670, G1000, etc. On these other models is shows put the #1 piston on TDC and setting certain valves and then rotating the engine to have #4 for M670 or #6 for G1000 on TDC and then setting the remaining valves. For the U302 it does not describe this at all so once again I am concerned about how the flywheel has been installed and if this is correct or not and if anyone knows where I can find the valve tappet procedure described or is it considered to be the same as the M670.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.