Posted by century farmer plus on October 22, 2012 at 14:22:37 from (70.34.183.34):
Hi folks, I have enjoyed reeding this forum for years and wondered if some one can help me out. One of our jet star tractors (brown 61-62) the weld broke on the shaft that goes through the bearing cage assembly and then theres a heavy metal plate the inner tie rods attach to. I have an IT manual and it looks much like fig. MM612-335 but not exactly, paragraph 15 page 10. I have removed the snap ring from the top, my question is can I use a pulley puller to remove the sttering sector? I need to get this shaft out so I can weld it strong back on the bottom plate. Also can anyone tell me which lines go where on the power steering valve on this tractor? PS hasn't worked in years and I may have some thing crossed. thanks for your help. jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.