Posted by molinegb on October 17, 2012 at 12:13:52 from (67.201.136.21):
In Reply to: Re: GE5002 Pistons posted by Charlie Bilerx on October 16, 2012 at 22:08:25:
I always get LE and Ge motors mixed up. It is open flywheel 1930 21-32/FTA motor. Blocks and pistons had at one time been upgraded from the original 4 1/2 setup to 4 5/8. Tractor had been sitting for 40-50 years in a pasture. No can over exhaust and no hood. Pulled motor apart and found it had been rebuilt. Pressed out pistons easily. Cleaned bore and found no ridge or severe pits. Had several pistons out of GT's but GE2's were is best condition. I checked some NOS rings that I had. Found 5-3/16" compression rings,1- 1/4" oil ring and 4- scrapers.Salvaged remaining rings from GE2 pistons. I've been looking for blocks and pistons for some time. I now have enough parts to assemble my next project. 1938 GT Thanks for info.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.