Posted by pmer on August 25, 2012 at 12:36:28 from (184.108.40.206):
I'm thinking about taking out the 425 LP and putting in a 504 LP. Using it for 7000 lb county fair pulling. I understand the 504 has more power and probobly a better head, cam and governor too?
I do have some 605 parts. But it's an older 605. Is there a piston with compression height to match the short 4 5/8" cylinder block to a 6 inch stroke?
If this 504 is healthy I might run that way for a season to see how it does. I have ran the 425 a few times with 16.9 x 38s in 7000Lb. I don't pull to win but want to have fun. Best it done so far is a third place and that day it beat a 4010 and a 3010. The track was wet and I think I had a better tire for that day.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.