Posted by super99 on July 14, 2012 at 18:03:16 from (22.214.171.124):
In Reply to: splitting G1355 posted by MikeO-WI on July 14, 2012 at 17:15:49:
Look that over real close, Oliver made that tractor. I haven't been around one for quite a while, but I'm pretty sure you pull the motor and Hydra Power unit, set it on the floor and then seperate the motor and Hydra Power to get to the clutch. If it has the heavy cast bath tub frame, that is how you do it. Motor and Hydra Power slide ahead a few inches to free itself from the rear end. chris
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.