Posted by mmoon on December 17, 2011 at 13:09:35 from (76.100.220.32):
In Reply to: 336 head bolt torque posted by east bound and down on December 17, 2011 at 12:07:16:
there is some veriations-depending on model-on 5star-m5-m504-non diesel eng-tighten head nuts to 130lbs on camshaft side---110lbs on exhaust side---. on the 602-604 non-diesel tighten to 175 lbs .-on the 670 -670 super non-diesel tighten nuts to 175 lbs---these are used on the 5/8studs---i have done mine this to my 670 with no problems --i did not have copper gaskets. i was very careful after 125lbs and used 10lbs stages in case of a weak stud and used new nuts and washers-and followed the sequence in the mamual. do not use regular nuts &washers off of the bolt store as they will not take this amout of torque---hope this helps --
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.