Minneapolis Moline Tractors Discussion Board |
Re: 800 HD Horsepower
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MM 800 on March 20, 2007 at 13:42:49 from (63.241.174.129):
In Reply to: Re: 800 HD Horsepower posted by willywonka2 on March 20, 2007 at 12:57:06:
OK, I'm going to split a hair or two here. Technically speaking the 800 motor is a couple of cubes short of 800. The spec sheets state that it is a 5-5/16" bore with a 6" stroke. That calculates out to 797.97 cubic-inch but 800 sounds better when you are marcketing an engine.
Replies:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|