Minneapolis Moline Tractors Discussion Board |
Re: ZAU engine parts
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Augie on December 06, 2005 at 16:50:51 from (69.29.86.231):
In Reply to: ZAU engine parts posted by 1031D on December 06, 2005 at 09:42:58:
Unless your blocks are really bad corroded in the water jackets you won't have any trouble at 3.75". The .125" overbore only thins the cylinder walls by .0625". There are some out there running at 3.875". It takes a pretty good set of blocks to hold that. Going from 3.625" to 3.75" gains you 14ci. If you're looking for horsepower there's more to be gained by improving the air flow. Welters sells a set of 3.81" Jahn's pistons for $69/hole. Not a bad deal if you skip their $135 rings and buy those at your friendly local auto parts store for $70 or so.
Replies:
Home
| Forums
Today's Featured Article -
Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|