Massey Harris & Massey Ferguson Tractors Discussion Board |
Re: Proper way to disengage spinning PTO. on 135
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Big Dean on June 23, 2006 at 09:25:06 from (205.188.116.71):
In Reply to: Proper way to disengage spinning PTO. on 135 posted by 02 on June 22, 2006 at 19:23:23:
At the Massey Ferguson service training class we were told to idle the engine down to low idle speed with manual pto push the clutch pedal completely down to release the pto clutch and shift it in to neutral. With the Independent pto when the engine is at low idle disengage it. To engage it the engine should be at or close to low idle speed . Then after it is engaged raise the RPMs to pto speed.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|