Posted by GregBMF on April 26, 2014 at 13:46:59 from (22.214.171.124):
In Reply to: MF 70 posted by GregBMF on April 01, 2014 at 00:09:50:
Well after getting it home and checking a few things on it, it turns out the pressure to the trans clutches is fine, but the pressure to the converter is low. The manual states that it should be 80-100psi warmed up @ 2K RPM. I only see 80 when cold, and as it warms up the pressure starts dropping. It doesn't have the power to push much dirt with the bucket even in low. And I did get it to shift into high coming back down my driveway, so the clutches seem to be fine, just not getting much through the converter. I will pull the charge pump when I have some time and disassemble and check the pressure regulator and relief valves.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.