Posted by Roy in UK on April 27, 2013 at 03:44:47 from (86.139.46.119):
In Reply to: Re: lower link ? posted by samn40 on April 26, 2013 at 16:05:20:
I never had any trouble with my balls thank you as I liked to keep them lightly oiled! BUT our MF 168 had those lower links where the ball ends were retained by a pin, the pins themselves were notorious for getting seized . Taking them out often involved much WD40 and patience for fear of bending them / snapping them off. It was usually easier to leave the cat 2 ball ends in all the time and if I needed to use it on a cat.1 implement, just fit them with the adaptor sleeves.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.