I did it kind of mix 'n match. The pump, control valves and drive to pump lovejoy coupling I got from Surplus Center, the harmonic balancer insert and pump drive I got off this site. IIRC, the whole magilla probably ran around $400, but that was a few years ago. My tractor has an AD 192 instead of the 203, so my harmonic balancer was a hair small for the drive insert. I had to buy a used balancer from a 203 and have the seal surface machined a hair to fit through the engine case, so that added a couple of extra bucks.
You have to cobble together a sump out of 1/2" black pipe and bore a hole to modify the pto shifter cover plate for a fitting. Helps if you have a torch to heat and bend the pipe to clear trans innards as required. I just ran the return to the top cover.
Pretty easy job, just takes a little finaglin'. Hardest part was cutting the front weight rack accurately for the shaft drive and pump mount to keep the pump and drive shaft aligned properly.
If you do a search under "Massey 65 Front Pump" you'll find a ton of info here. Increases the utility of the tractor quite a bit insofar as using a hydroswing haybine or a round baler.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Magic Moments - by Tyler J. Woods. Magic moments don’t just happen. You have to help them along. This morning, I got up early. It is my day off from my regular workweek and I had a lot of things to do. It’s fall, and with winter coming on, there is a lot of work to do before weather closes in.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.