Posted by Robert Major on March 08, 2013 at 17:44:31 from (216.81.16.141):
In Reply to: 175 engine problems posted by DennisinWI on March 08, 2013 at 09:33:28:
Hi Just a few thoughts on this. I"m working on a 3.152 Perkins motor right now. The pistons that are in it have multi piece oil control rings with 5 parts . when I was looking at ordering the parts there was an online tech sheet that said these ring parts had to be installed a certain way. I wonder if you had these type rings and they are put together wrong. glazing is possible but I never had a motor this bad from start up and a few hours from rebuild.
I wonder could there be a miss match on rings to chrome cylinder sleeves i know some perks had chrome and some cast and seem to remember the rings have to match right for the sleeve type but not sure if your motor could have both types fitted. The other thing that might sound stupid, is the muffler full of oil from before the repair and as it heats and revs it pushes it out more. I had a Belarus in the shop once for a guy. I did the head on it. It had been lightly used and started with either due to bad valve seats. when I got it running it slobbered stuff from the exhaust after an hour warming. I thought here we go more problems and the rings are bad as the guy never wanted the pistons pulled or anything else checked. I started thinking and took the muffler off. it was full of sticky goo that was also in the head on removal. so I took a tiger torch, set it in the inlet of the muffler and burnt all the goo out. it whistled like a jet motor for about 10 mins. I put the muffler back on and it never slobbered again. Hope something here will be useful or someone else will know about the rings and sleeves. Regards Robert
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.