I was able to get the tractor split this weekend. I ended up using an engine lift to support the rear end while I rolled it back. Was much easier than I anticipated. I was also able to remove the aux pump and disassembled it for inspection. The pressure plate was pretty badly worn and the seals on the back side had ruptured. Could also see where the housing had been eroded a bit. The new pump is ordered.
One thing I was going to ask about. I've noticed this tractor is very particular about the lift quadrant positioning. It has the pressure control system and it seems like its always creeping the lift up or down unless I get the quadrant set to just the right place. Is this something I should look into adjusting while the rear end is disassembled? The service manual doesn't seem to be too clear on how this system works.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.