Better measure the bearing clearances with some Plastigage!Did you put in a new pumpor rebuild the old one. Did you check the relief valve and spring? Check to make sure that there is no leak in the oil pick up tube that"s not allowing the pump to pick up oil. The oil line to the gauge does not need to be primed with oil. Make sure the oil line isn"t clogged-blow it out with compressed air. Pull the coil wire out of the tower, remove the oil line at the block,pull the spark plugs and crank the engine over to see if you have a bunch of oil come out. Run a wire into the block to see if some swarf is clogging it. Crank again,If you don"t it"s "Houston, we have a problem" time.
The gauge usualy works or it doesn"t. It may not be accurate, but it should show pressure unless it"s really damaged. Blow some compressed air into it an see if it moves. If it does, it"s working(again it may not be accurate).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.