If you have tried all the sleeves in that hole I'm thinking the o-ring bore is off center holding that sleeve tipped in the bore. Every thing needs to be clean enough so when you dry fit the sleeves they drop right in, not push in, drop in with a klank. I would put some prussian blue around the top flange off that hole and see if your are getting a seat on the bottom side of the top flange. First check the deck of the block and make sure it's good. The flange of the sleeve absolutely has to set flat in the upper bore or it will break or crack. I'm thinking you may have to move the bottom bore where the 0-rings go over some to let that sleeve set flat on top. maybe possible with a drum sander or similar set up. If your sleeves all are setting flat on the flanges and the deck happens to be off by that one hole the head should seal on the sleeve ok and the gasket should be ok to take up the difference around that cylinder. I'm thinking that sleeve is tipped in the bore though.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.