Posted by Samuels68 on January 22, 2013 at 18:45:43 from (173.215.11.129):
I'm sure that what I am about to reveal is not news to most on this forum, but if it might help someone, I thought I would put it out there.
This weekend, I got my 20 running for the first time in a couple years, and it had a terrible exhaust leak (the rear gasket was....gone). No big deal, removed the manifold, went and got some high temp gasket material, cut new gaskets etc. I decided since I had everything apart I would change the studs. (This decision was helped along by the fact that I broke one of the studs during removal.)
After 2 days of soaking the studs with penetrant each time I walked by, I got the vise grips out and proceeded to remove the broken stud. This is where it got interesting....
Apparently, the holes in the head are tapped right into the coolant channels in the head, because when I removed the stud, I got a cold, slimy green surprise!! Of course, the shock of 17 degree antifreeze shooting out at me caused me to drop the stud, which rolled under the tractor. By the time I looked around, grabbed the nearest thing that would contain the coolant (an old ice cream bucket) and shoved it under the hole, I have no idea how much coolant hit the floor, but lets just say I need to restock on floor dry!!
I planned on draining and flushing the cooling system, I even have the new coolant in the cabinet already, but I guess I got an early start!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.