Posted by samn40 on December 24, 2012 at 01:04:26 from (22.214.171.124):
In Reply to: transmission leak posted by marty lucier on December 23, 2012 at 14:08:17:
Just be careful when removing the front bearing housing from the gearbox as there is a thrust washer in there that could fall down.....simply raise the front of the 'box slightly so it remains on the shoulder and be gentle when pulling that shaft. I have found the sparex seals we get to be too large for the shaft so I just take the shaft and housing to a bearing and seal stockist as Mickey said. Also check the shaft for rust pitting where the seal runs. The old leather seals attracted moisture and if sitting for a long time this caused rust. Sam
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.