Posted by Brian I. on December 20, 2012 at 07:03:57 from (22.214.171.124):
Hello. I am in the process of replacing the rear lift cylinder due to excessive scratches in the cylinder lining and piston. When I reassemble the lift, I was considering trying to calibrate the position/draft control. However the manual I have keeps referring to use Massey Ferguson special tool#... for this and special Massey Ferguson wedge# for that.... I have no idea what these are and I"am not likely to get ahold of these tools. Can someone describe to me if these tools can simply be made...are they simply small pieces of metal of a certain thickness & dimension??? Any help or suggestions would definitely be appreciated. Thank you.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.