Hi Gerard, There are three versions of the hydraulic pump fitted. The filter is in essentially the same place at the rear of the pump but access is different. If your tractor is a later one look first on the underside of the rear centr housing, roughly on a line from the transmission dipstick but on the underside. You may see a triangular plate held to the casing by three nuts or bolts. Drain the transmission and remove the plate. Inside you will find a spring clip and then a nut. Remove both and the filter will drop out. If you don't have the plat access can be gained through the left hand side-cover. This however will depend on what equipment is fitted such as IPTO or auxillary pipework, Assuming you don't have eithe and you have removed the cover you should find that the top of the filter is wired to the backplate of the pump. Cut the wire and use a small pair of pliers to undo the butterfly on top. Try and lift the complete assembly out as one. You will have the top cup, filter and bottom cup. There is a thin section O ring which normally stays on the pump. Ensure that it is not lost. Clean or renew the filter. If you don't have proper locking wire use a domestic electricalwire strand (cooker cable). Twist the wire ends after threading through the butterfly and backplate. Be careful as there are many potentially sharp edges on components around the filter. Replace the cover and refill with oil. If you have IPTO or aux pipework it may be necessary to remove the cover.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.