Hi Stoneman, First of all your steering system should look like the one shown in the photo. Have you adjusted the end float in the cross-shaft of the steering box? If so, there is a 'high spot' in the straight ahead position. It should be adjusted so that it just passes this freely. Have you refitted the pipes correctly? The top pipe from the pump goes to the front port on the spool valve. With the engine stopped have an assistant turn the steering wheel in the play created by correct adjustment of the tapered screw that has the big nut on top. Observe the spool actuation. From a central (neutral) position the spool should move equally in either direction. If you do not have sufficient and equal movement of the spool in both directions you will not have any assistance. Check for any reluctance to return to the neutral position. Its possible that the adjustment might be incorrect and allowing some pressure to reach the cylinder. By revving the engine you may just create enough flow to turn the steering. To adjust the steering the adjustable barrel should be disconnected at one end. Screw the tapered screw down until the two arms are locked together. Adjust the barrel so that the pins can just be fitted. Unscrew the tapered pin SEVEN turns. That is the initial adjustment. Nip the lock nut. Have your assistant turn the wheel back and forth and observe the movement. Look for any play in the pins/spool yoke/steering arm/vertical shaft bushes/shaft/cylinder rod anchor point in the axle casting. You are unlikely to have any axial play in the rod but 'up and down' in the casting will destroy the efficiency. The vertical shaft grease nipple should be visible from the left hand side on the front side of the axle and about 4 inches directly above the clamping bolt for the bottom steering arm. If you don't get anywhere disconnect the outer ball joints and jack the front up. Make sure that each wheel steers freely. Please let us know what you find. DavidP, South Wales
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
