I finally found a postive grounded gas gauge from a&i, It says 12v on it. I used a circuit tester on it (2-AA batteries, 3 volts), my fuel sender is 30-250ohms, when the sender is at it's highest resistance using the 3 volts, the gauge reads empty and then reads full with 30ohms resistance. it reads full all the time in both with the 12 volt tractor battery. But, the gauge only works in both cases , when the ground is negative. U.K.mf 35 tractors were 12 postive grounded, why is my U.S. tractor postive grounded when the rest are negative? It's a pain in the butt! I'm trying to get my supplier to replace the gauge, it's got to be deffective!
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.