Posted by AndyS on September 09, 2012 at 15:25:45 from (184.108.40.206):
On occasion I have seen various comments about differences between the MF-35 model built in Detroit and the same model manufactured in Coventry England. Is there a list of the significant differences in the model based on where it was produced? Today I was doing brakes on a UK tractor and had ordered 830480M92. These are available from a number of sources, but only one states for US tractors only. Well they were right -the spring holes and shoe hold down pin holes were in wrong spot, plus the slot for the adjuster was 1/2" too long. I had to drill my own holes and grind down adjuster slot to make the shoes work. I would have liked to skip the extra fab work.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.