Posted by Joe Snodgrass on March 12, 2010 at 18:36:40 from (220.127.116.11):
I read on a web site last night that using a 3 point tiller on the back of a tractor was hard on the pto clutch. Is that so?
Also, will a 3 point tiller work OK on my MF 255? I have 4 forward gears and a Hi/Lo range. I know that I would need to use 1st gear - Lo range with a tiller but wondered if that would even be too fast at 540 rpm.
Also, anyone got any recommendations on the brand of tiller I should get and whether it should be "counter rotating" or "forward rotating"?
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.