John Deere Tractors Discussion Board |
Re: Re: Re: Re: 4620 value
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by G-MAN on December 05, 2002 at 11:02:57 from (206.106.139.74):
In Reply to: Re: Re: Re: 4620 value posted by lpman400 on December 05, 2002 at 08:13:25:
What was the breakdown of the bill between parts and labor? $13,000 seems pretty high for a tranny job on a 4840, unless it is new throughout. A completely new clutch pack and brake pack list for about $10,000 total. Did they install new units or just replace the bad pieces? If they put in new, the cost would probably be pretty much in line, as $2000 labor would probably be in the neighborhood of 40 to 50 hours, which is about what it would take to do the whole job. And the other $1000 would cover other needed parts such as gaskets, torsional damper and so forth. I was just curious what all they did on your tractor.
Follow Ups:
Home
| Forums
Today's Featured Article -
Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|