John Deere Tractors Discussion Board |
Re: Crank Timing
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John T (Yo Clooney, u got more to help here?) on November 20, 2002 at 07:30:34 from (67.241.61.69):
In Reply to: Crank Timing posted by Jim on November 19, 2002 at 16:41:11:
Jim, well no one else is hitting on this lol so I will at least discuss it. If you absolutely can not find a mark or punch on the crank gear, I have timed cam to cranks before, simply by looking at where what valves were at the proper time, but Im sure you can figure that withiout any advice. I would study number one left cylinder and see if you can time the crank to where the intake valve opens when the piston just starts down on its intake stroke, and is totally closed, of course, when it gets to the bottom. Then as you know, the piston will come back to top (no valves will open or be open) and go all the way back down (and just start back up) before the exhaust valve opens, which is then, again of course, closed at top. If it does all that, you are surely within a gear tooth of being right. Then, when the left piston is at TDC on its power compression stroke, the governor to cam gear is timed so its female drive cog slot (that mag fits into and is driven) should be flat horizontal. Other timings are the clutch disk versus the flywheels placement on the correct splines. They often have a v mark or a dot that lines up. If you get the flywheel on the right spline, its LH Impulse mark should be horizontal at 3 O Clock lined up with a mark on side of tractor when left piston is at TDC on compression stroke. Other thigns regardign timing are the clutch disks and flywheels heavy out of balance sides MUST be 180 opposite from each other to avoid serious vibration. This is about all the smarts I have concernign the subject, and as Forrest Gump says, Thats all I have to say about that. Good luck, Ol John T
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|