John Deere Tractors Discussion Board |
Re: Re: 47A block to Crank case torque spec.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jim on November 15, 2002 at 08:48:58 from (209.105.187.163):
In Reply to: Re: 47A block to Crank case torque spec. posted by Morgan on November 14, 2002 at 18:31:16:
Morgan------assuming that the head is torqued at 150.the block bolts should be about the same----.I am still searching for true J.D. specs.----Some where in my shop I have some older shop manuals that tell torque specs, for the bolt hardness and size of bolts,I think i'll have to hunt them down and see how close 150ft.lbs. will be.I do hope there is somebody out there that knows the actual torque spec. By the way,how did you make out on the block gasket?-----thanks jim
Follow Ups:
Home
| Forums
Today's Featured Article -
Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|