John Deere Tractors Discussion Board |
Re: John Deere Cast Iron, Four-Spoke Steering Wheel
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Walt in Jaxn, Tn. on September 14, 2002 at 20:16:26 from (24.159.76.232):
In Reply to: John Deere Cast Iron, Four-Spoke Steering Wheel posted by (Mr.) Kim Walker on September 14, 2002 at 01:12:48:
congradulations, what you have is a hand crank start assist wheel for pre 1947 electric start horizontal john deere tractors. a shaft was placed in that wheel and the shaft had a pin thru the other end that fit in the slot on the cast iron hub of the flywheel-----walt
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|