The best way to check if the float has a hole in it is to take it out, and submerge it in a pot of HOT water. if you see bubbles coming from it, there is a hole. it no bubbles the float is fine. Easy trouble shooting. the ONLY way to properly rebuild a TSX carb is to remove the fuel nozzle. it has orfices drilled in it that plug and with out them cleaned out the tractor will never run properly. I have had to drill the nozzles out because the screw driver slot has become stripped over the years. this is very time consuming but well worth the effort. A new nozzle is about 40 bucks. just be carefull not to drill into the cast threads. Also install a new throttle shaft as the old ones get wore. Get a full rebuild kit, the shaft is included. Good luck. and when you get that carb rebuilt properly your tractor will run like never before. Remember, the best carb rebuild is to start with a clean gas tank. because dirt in your carb is the worst enemy and a visious circle
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
