Posted by 4010 puller on July 08, 2013 at 06:23:01 from (70.199.2.20):
In Reply to: A timing posted by rosedale123 on July 07, 2013 at 18:53:35:
As per jd operators manual for a 60. #1 cylinder is flywheel side. Remove spark plug, roll flywheel in direction of normal running travel by hand, keep finger over sparkplug hole so you can feel compression stroke. It says to go to 5*ATDC
(5 degrees past tdc;flywheel should be marked on top/thin side near ring gear with tdc and some degree numbers)that mark should line up with notch in timing cover inspection hole.
When you are at that point, loosen distributor and roll it forward. With top sparkplug wire on distributor removed from sparkplug end (hold sparkplug end on a piece of metal to see spark) Roll distributor towards back of tractor slowly until you see a spark. When you see a spark stop turning and tighten distributor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.