Posted by rockyridgefarm on June 14, 2013 at 06:20:41 from (69.131.203.82):
Hey all,
So putting a torture box (aftermarket cab) on the 4010 is out, as I figured. Putting a SG cab on my 4430 OS is still gonna be around $5000, so that's undesirable. Just flat adding a tractor is not justifiable (Last year, I put 10 hours on my 60, 75 hour on my half 2040, 100 hours on my 4010, and 75 hours on my 4430, and I just picked up my grandpa's 3020)
How about I sell my 4010, put 16.9-38s on 14 inch rims on my 4430 for cultivating 30 inch rows on contour strips (so much heavier than my 4010...), and buy a 4630 cab tractor as my big hoss for 10K at a local jockey's place? My big tractor needs to pull a 14 foot BWF with 18 foot spring tooth harrow and 5-18 IH plow. These are EVERYTHING my 4430 wanted - they work it hard. It also needs to run a 375 bushel spreader and Degelman dozer blade on occasion.
Big problem with this plan is I just got done spending beaucoup bucks on my 4010 - 30 series front end, rebuilt hydraulic pump, newer diesel engine out of a 4430, new clutch, new rear rims, new hydraulic valves, new brakes - everything but the tranny (knock on wood). I'll never get back out of it what I have in it and I've hit all the bad parts in the tractor, so it should be dead reliable.
All this decision making to get a cab to give my 4 year old boy a relatively safe ride in a tractor...
This post was edited by rockyridgefarm at 06:22:13 06/14/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.