Posted by Cockbird_Hunter on December 21, 2012 at 06:52:12 from (22.214.171.124):
In Reply to: H main bearings posted by Mike(NEOhio) on December 20, 2012 at 18:41:46:
To remove the pressed-in RH (Blind) main bearing, I have scored & cut through the bearing with a Sawzall metal blade being careful not cutting into the bearing housing.
I sent my rods to Paul's Rod & Bearing (Russ Schworer 816-587-4747) for rebabbitting.
For the mains, I ordered new press in bearings from Sharp's Antique Tractor Works In MO.
I then had my local auto machine shop turn the crank main & rod journals then machine the rod & main bearings to 0.002" > the machined crank rod/main journal dimensions....It's a little tricky with the right hand bearing being blind...
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.