Posted by PopinJohn on December 04, 2012 at 18:10:30 from (220.127.116.11):
In Reply to: dltx10 problems posted by Ryaninks on December 04, 2012 at 17:19:28:
The engine should die with the idle mixture screw closed. If the passages in the carburetor are clean, the tractor should run at WOT with the idle mixture about 1-1/4 to 1-1/2 turns open. The IDLE mixture adjustment does not mean idle RPM. It means "unloaded" at any RPM, and should be open enough to stop governor surging at WOT, but not open enough to give black smoke. However, adjusting at WOT may be too rich at slow RPM, so,your final setting may be a compromise between top and slow RPM setting. Engine should be warmed up pretty good for adjusting. On most B's, the load needle will be right at 3/4 to one turn out. MikeS.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.