Posted by JD4440_K on November 15, 2012 at 18:24:24 from (75.239.18.9):
Last year I replaced the rear tires on my 4440 and decided not to put the fluid back in. My tractor had 20.8X38 tires. I use the tractor for a loader tractor and a backup for tillage work. Any suggestions on how much weight to add?
The factory option shows 440 lbs weights which run $800 a set based on my checks at several salvage yards. Today I did a little research and found that the 1,500 lbs weight that fits a 4640 will fit my center castings. They don't show the 1,500 lbs weight for a 4440 but do show it for a 4450. The center dish casting part number is the same on a 4440, 4640, and 4450 so I know the weights will fit. These weights can be bought for $1,000 a set but I need to drive a little futher to get them. So my question is are these overkill for the tractor?
Based on my calculations, I don't think this would be any heavier than fluid, thoughts???
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The David Brown Rose Badge - by Samuel Kennedy. In the 13th century civil war was raging in England. Two English noblemen were involved in a conflict which became known as the War of the Roses. The Duke of York had as his emblem a white rose and the Earl of Lancaster had a red rose. Today the white rose is the official emblem of the county of Yorkshire and the red rose has been adopted by the neighboring county of Lancashire.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.