Sounds like we're talking about the same rod. I just wish I could figure out how to put a picture into these posts. What mine had was a frame running horizontally from the two sides around the back of the battery case. In the center of the back were two small ears welded on with a hole through them. It also had a pair of diagonal braces. It was made in three pieces and welded while on the tractor. There no nuts on the ends and could not take it off without cutting. No paint either so I'm sure it was home built. Almost looked as though it was for 3-point top link but much too light.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.