Ok, I have adjusted the rear wheel up, in fact last summer when I ran the plow I had the rear wheel removed. Could you describe the process of lowing the hitch again? I belie that is my problem (or a big part of it) but I just can't seem to figure it out. Am I loosing up the rod with the spring attached? I am new to running I implements like this, but I really want to figure it out.
Also, you said that I wanna use a angle grinder on the rusty plow, but that you wait "it WILL not interfere with the plow soil contact area". Am I just misreading this, or does grinding the plow not really help?
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.