Posted by Charlie175 on October 28, 2013 at 05:29:11 from (184.6.168.3):
This is a Rooster comb trip plow on rubber.
The right wheel had some play in it so I removed the bearing cup thinking there was a bearing in there. I was wrong, there are not bearings on the wheel! The outside has a cam with several slots that can be used to adjust tension, next was a large ring that presses against the wheel hub. On the back side is a cup with a bolt that goes in a counter sunk hole to lock the cup in place. However with this in place, and with the cam in the correct position I have 1" of play! So I must be missing something as the P.O. used the rear cup to slide in further than the correct position and locked the bolt down on the axle. Does anyone have a diagram? I can't imagine why they didn't use a bearing. Unless they packed it full of grease you had metal on metal wear.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.