Cannot find a manual in my stash of manuals for that number but unless I am mistaken it is just a newer version of the 30. Does it have a arm comming out of the gear box that a trip rope fastens to? If it is like that And I had what if I remember correctly a parts 254 and a parts 30 and the parts were the same. So if that is what I am thinking then follow this. Unbolt the lift cover and take it off lifting straight up, after you do that clean out all the old grease so you can see the parts and to get rid of any broken parts so they do not chew up the bearings or gears, get it as clean as if you were going to paint it. Now look fore several small springs inside that like to break. Part no. 0432 HS, Lift paul spring, Compression, 5/8" OD, 2-5/8" long. 11 coils. Next is 0436 HS, Clutch spring, extension, 9/16" O.D., 2-11/16" long, 26 coils. 0437 HS, Lock paul spring, .035 x 3/4" flat, 7-1/4" long. 0576 HS, Back stop spring, compression, 7/16"I.D., 13/16"long, 3-1/2 coils, 2 used. 4 part numbers in 5 springs. If any part of any of those springs are left in they will tear up your gears or bearings, that is why I say clean very good. There should be 5 bolts holding it on, 2 3/8" x 1", 2 3/8" x 2 1/2", and 1 3 1/4" long bolts and the 3 longer ones have a nut on the bottom. Both mowers I had bought for parts for a No. 40 that I have but it is the scarce semi mount type but the cutter bar parts are the same but both parts mowers had that clutch lift gear box broken. Do not try to put a spring on the outside as you will just destroy the inner parts with the broken parts. And no I do not know where to get the springs, if you can find all of the broken springs then you might be able to match something up at a hardware store.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.