Posted by Tx Jim on September 12, 2013 at 12:05:07 from (69.35.163.56):
In Reply to: measuring disk width posted by Leroy on September 12, 2013 at 11:18:58:
Leroy said: (quoted from post at 14:18:58 09/12/13) On tandem disks both John Deere and IHC measuere the cut on the back gang, only do the measurements come off the front on a single gang disk. The back gang is the total width of cut, front is not.
Leroy
I think that's incorrect. Try to pull a 12 or 14 ft disk through a 12 or 14 ' gate respectfully or any gate the same size as the tandem. It a'int happening, I've seen tandem disk sizes listed in parts catalog but I never seen where PC states measured at the rear gangs. The 13' 10" JD 310 I owned was a little difficult to get through a 16" opening.
Disk gang bolt on an 8' JD KBA is 46"s long
B10482 GANG BOLT 1 28.575 X 1 174.750 MM (1-1/8" X 46-1/4") (8' SIZE)
This post was edited by Tx Jim at 12:22:25 09/12/13 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.